驱动气体的压力和流量
Pressure and flow rate of driving gas
一切的泵和动力单元在连续工作时运用的驱动气压不超越0.69mpa，在间歇工作时可达1.03Mpa。在佳性能状态时气动泵的耗气量，请参照所需驱动气体流量表。
The driving pressure of all pumps and power units in continuous operation does not exceed 0.69mpa and can reach 1.03Mpa in intermittent operation. In the best performance state, the air consumption of the pneumatic pump, please refer to the required driving gas flow meter.
工作压力和流量
Working Pressure and Flow
一切的泵和动力单元的工作压力参照驱动气压为0.48mpa时泵输出压力和流量。假如泵的较大输出压力大于所需的工作压力，这就要思索平安措施。关于较大输出压力，请参照产品目录中"静态下驱动气压力和输出液压近似比率表"。动力单元的选型与泵分歧。关于工作流量，请参照产品目录中的"性能曲线图"。
The working pressure of all pumps and power units refers to the output pressure and flow rate of the pump when the driving pressure is 0.48 mpa. If the maximum output pressure of the pump is greater than the required working pressure, it is necessary to consider safety measures. For maximum output pressure, please refer to the "Approximate Ratio Table of Driving Pressure and Output Hydraulic Pressure under Static Conditions" in the catalogue. The selection of power unit is different from that of pump. For workflow, please refer to the "Performance Curve" in the product catalog.
保送液体介质
Delivery liquid medium
液压密封圈是丁橡胶和聚氨酯，单向阀座采用特氟龙密封。其它密封资料包括碳氟化合物和亚乙基丙烯，这些密封资料主要用于保送的特殊介质。请向工厂或当地的分销商咨询密封资料选型。
The hydraulic seal rings are polybutadiene rubber and polyurethane, and the one-way seat is sealed with Teflon. Other sealing materials include fluorocarbons and ethylene propylene, which are mainly used for special medium for delivery. Please consult factory or local distributor for seal information selection.
可承受的体积和重量
Affordable volume and weight
关于某些的应用，泵和动力单元的外形尺寸和重量也要重点思索。
For some applications, the size and weight of the pump and power unit should also be considered.
This article is written by Gas Supercharging Pump. For more products and more details, please pay attention to our official website: //keonnected.com. Your patronage is a great support to us.
