1.首先初次使用要确保液体增压泵是按厂方要求连接，不要用低于液体增压泵高使用压力的配件如：高压管路，卡套接头，高压开关等。
1. First of all, the first use should ensure that the liquid booster pump is connected according to the requirements of the factory. Do not use accessories lower than the maximum use pressure of the liquid booster pump, such as high-pressure pipeline, jacket connector, high-voltage switch, etc.
2.在使用合适的配件下按使用要求以此连接好，再检查是否有泄露（液压和气压不同稍微泄露会导致压力浮动较大，再次增压会形成脉冲对产品精密部件有影响）。
2. Connect with the appropriate fittings according to the use requirements, and then check whether there is leakage (slight leakage of hydraulic pressure and air pressure will lead to a larger pressure fluctuation, and re-pressurization will form a pulse on the precision parts of the product.
3.在满足上述条件后再检查驱动气源是否满足使用要求，被增压的介质是否纯洁和连接好
3. After satisfying the above conditions, check whether the driving gas source meets the operation requirements, whether the pressurized medium is pure and well connected.
4.完成以上步奏后打开驱动气源，调节二连体上的压力调节阀，从压力0往高处调节至所使用压力，等液体增压泵高压出口有液体排出时证明增压缸内空气完全排出，切断驱动气源，连接被检测件再打开气源。如果检测在长时间内承压能力就不用切断气源，检测密封性2种办法：1，切断气源看压降2，保持气源畅通看渗漏。
4. After completing the above steps, open the driving gas source, adjust the pressure regulating valve on the two-connected body, adjust the pressure from 0 to high to the used pressure, and prove that the air in the booster cylinder is completely discharged when the liquid is discharged from the high-pressure outlet of the liquid booster pump, cut off the driving gas source, connect the detected parts and open the gas source again. If the pressure bearing capacity is tested for a long time, there are two ways to test the sealing: 1. cut off the gas source to see the pressure drop 2, and keep the gas source open to see the leakage.
This article is dedicated by the gas booster pump. For more knowledge, please click: //keonnected.com. We will use advanced technology and sincere attitude to provide you with comprehensive services. More knowledge will be dedicated to you one after another. Please look forward to it.
